News

Design of injection mold for toy car casing
As shown in Figure 1, front features of plastic part have 1 rectangular side hole, 1 deep rib, 2 sid...
News2023-01-04

Some related data for injection molding
Due to complexity of injection molding machine processing, various small problems are often encounte...
News2023-01-03

Key points for setting operating conditions at each stage in injection molding
(1) Gradually heat up from the first stage (feeding place) to third stage (before nozzle), temperatu...
News2022-12-31

How to set reasonable injection process parameters?
Debugging of injection molding machine refers to continuous adjustment of various parameters of inj...
News2022-12-30

How to use sensors to conduct an all-round medical examination for injection molding manufacturing -
Whether in automotive industry, medical technology or electronics industry - zero-defect production ...
News2022-12-29

Correlation and difference between plastic machine process and mold flow analysis data
Abstract: This paper focuses on analysis of Moldflow software, compares data analyzed by software wi...
News2022-12-28

Master melt temperature through plasticization analysis
Plastic temperature control in injection molding usually uses rotation of screw and heating plate on...
News2022-12-27

Flip-chip injection mold design for searchlight cover
Searchlight cover product is shown in Figure 1. Maximum external dimension of product is 362.40 mm *...
News2022-12-24

Advantages and disadvantages of glass fiber reinforced nylon and solutions to problems easily caused
What are advantages and disadvantages of nylon reinforced with glass fiber? What problems are prone ...
News2022-12-23

Application of High Gloss Injection Molding Technology and Installation Configuration
High-gloss injection molding technology, also known as rapid thermal cycle injection molding technol...
News2022-12-22