What are principles and core of injection mold design?

First, mold opening direction and parting line
Each injection product must first determine its mold ...

News2026-09-17



Injection Molding Common Defect Troubleshooting Manual: A Systematic Solution from Short Shot to Cra

No abstract theories or formulas. Each defect is addressed following logic of "Symptom → Quick Ass...

News2026-09-17



CAE Analysis and Mold Design of Die Casting Process for Automotive Headlight Bracket

Abstract: Structural characteristics of automotive headlight brackets were analyzed, die casting pro...

News2026-09-16



Differences and Selection Techniques of Nylon Plugs and Resin Separators for Injection Molds

In design and production of injection molds, both nylon plugs (also known as resin sealers) and resi...

News2026-09-16



Developing Thin-Walled Transmission Parts for Humanoid Dexterous Hands: 6 Key Mold Design Considerat

Miniature thin-walled transmission components for humanoid dexterous hands—such as planetary gears,...

News2026-09-16

Complete Guide to Injection Molded Part Structural Design: 22 Core Parameters + Avoidance Checklist,

If you are currently designing injection molded parts, you have likely encountered these problems: s...

News2026-09-15



Analysis and Improvement Measures of Die-casting Defects in Thermostat Housings for New Energy Vehic

Abstract: This paper addresses issues such as poor airtightness, core erosion, and excessive flash i...

News2026-09-14



Design of Large and Thin-Walled Injection Mold for Hot Runner System of Automotive Left Front Door P

0 IntroductionAutomotive door panels are an important part of automotive interior components, locate...

News2026-09-14



Plastic mold | Introduction to gating system

(1) Large nozzle mold: Runners and gates are on parting line and are demoulded together with product...

News2026-09-11



A Comprehensive Analysis of Injection Molding Shortage Issues—Analysis and Solutions from Four Dimen

Insufficient filling, also known as short shot, is one of the most common and troublesome quality de...

News2026-09-11