A Comprehensive Analysis of Injection Mold Gate Types (Part 1): From Basics to Three Classic Gates

In injection molding, molten plastic is injected from nozzle and flows through runner system into mo...

News2026-08-21



Cost Reduction and Debugging for Three Types of Products (Thin-Walled, Deep-Cavity, Precision Gears)

Focus of cost reduction and debugging differs for three typical product types: thin-walled parts, de...

News2026-08-21



How to improve transparency of plastic products? Let's look at relationship between materials a

Due to advantages of plastics such as light weight, good toughness, easy molding, and low cost, they...

News2026-08-20



Design and Optimization of Die-Casting Process for Aluminum Alloy Two-in-One Housing Based on CAE An

Abstract: This paper introduces structural characteristics of a two-in-one housing for a new energy ...

News2026-08-19



Understanding Runners and Gates in Injection Molds: A Fundamental Concept

Molten plastic enters mold cavity from nozzle of injection molding machine through main runner, runn...

News2026-08-19

Design of Mold for Indoor Unit Base of Split-Type Air Conditioner

Generally, plastic molds only have an ejection mechanism in moving mold. For products with special s...

News2026-08-19



Injection mold's glue feed system: "Lifeline" of plastic molding

Without sophisticated glue feed design, even the best molds cannot produce perfect products.
Like hu...

News2026-08-18



How to solve shrinkage and warpage? Just read this article!

Warpage is surface distortion of plastic part that is not formed according to designed shape. Warpag...

News2026-08-18



Development of Die-Casting Process for Front Housing of New Energy Vehicles

Abstract: For a die-cast front housing of a new energy vehicle, numerical simulation was applied to ...

News2026-08-17



Injection Mold Design Specification

1 Scope
This standard specifies design requirements and methods for each system in injection mold de...

News2026-08-17