General principles and precision of structural design of automotive interior and exterior decoration

Complexity of shape and structure of product obviously increases complexity of mold structure and di...

News2025-06-30



CAE simulation: How does mold flow analysis predict molding defects such as warping and shrinkage of

Mold flow analysis (MFA) is an analysis method that uses simulation technology to simulate flow, pre...

News2025-06-28



Introduction to commonly used plastics, don't be confused!

Therefore, the most basic physical and chemical properties of plastics are determined by properties ...

News2025-06-27



Injection molding machine computer common fault diagnosis and troubleshooting alarm information caus

Injection molding machine computer common fault diagnosis and troubleshooting alarm information caus...

News2025-06-26



Solution to product defects in injection molding machines

1) Principle of EDM, EDM is a thermal processing method that uses electrical energy to convert into ...

News2025-06-25

Impact of bio-based and recycled plastics on molds

In the field of plastic processing, bio-based and recycled resins are increasingly used, and their p...

News2025-06-24



Die-casting process and mold design for rear end cover of automobile compressor

A compressor end cover casting is shown in Figure 1. Material is ADC12, basic wall thickness is 4 mm...

News2025-06-23



Answers to injection molding technical problems

"Answers to Technical Problems in Injection Molding and Injection Molding Machine Use"
1. Reasons ...

News2025-06-23



Mold support system design pit avoidance manual (support column/ejector block/spring hole/avoidance)

1. Layout points
Triangle principle: Triangle distribution at four corners and center of mold core (...

News2025-06-21



Common plastic material density/mold temperature/material temperature parameters


Material name Calcium carbonate Carbon fiber Glass fiber Talc Density Mold temperature Molding temp...

News2025-06-20