Introduction to nylon materials and their injection molding process

Polyamide (PA), commonly known as nylon, has a density of about 1.15g/cm3. It is a general term for ...

News2025-07-28



Material selection and analysis of plastic parts

Selecting suitable plastic particles or plastic raw materials is a complex but important process tha...

News2025-07-25



Design and practice of die-casting mold for electric vehicle inverter housing

Outline size of inverter housing is 560 mm×470 mm×110 mm, and average wall thickness is 3 mm. It m...

News2025-07-22



Design of mold for combined plastic parts

Product consists of two different plastic parts, as shown in Figure 1 and Figure 2. Outer dimensions...

News2025-07-22



Design and optimization of die-casting process for aluminum alloy heat sinks

Average wall thickness of heat sink on radiator in automotive steering system is relatively thick, a...

News2025-07-16

Analysis and Application of Two Forms of Hot Runners

When discussing technology and applications of open and needle valve hot runners, we first need to u...

News2025-07-16



Experience using MoldFlow

It is estimated that Moldflow software is still a single-CPU software and has not been optimized for...

News2025-07-15



The latest common plastic injection molding defects and solutions

Insufficient filling, short shot
Phenomenon-usually occurs at the end of flow or in the area where f...

News2025-07-14



Mold flow analysis analysis: key indicators and improvement strategies for weld line defects

Weld lines are common appearance and strength defects in injection molding, which are manifested as ...

News2025-07-11



Design of a new type of two-color injection mold

Plastic part is a shell with waterproof sealing function, as shown in Figure 1, with an outer dimens...

News2025-07-10