Design of a Large and Complex Inner Core-Pulling Injection Mold for Automotive A-Pillar Upper Protec

Automotive side panel interior trim assembly includes door trim assembly composed of door trim panel...

News2026-07-27



Daily Share: A Full-Chain Traceability and Closed-Loop Control Strategy for Unstable Injection Moldi

In injection molding production, dimensional instability is an "invisible cost killer"—it doesn'...

News2026-07-25



Design of Injection Mold for an Elongated Basket Based on Laterally Ejected Movable Core

For cylindrical plastic parts with circumferentially distributed side holes, if side holes have unde...

News2026-07-24



Research on Die Casting Gating Process of Automobile Engine Cylinder Blocks

Abstract: Currently, automobile engine cylinder blocks are mainly divided into two structures in pro...

News2026-07-23



Daily Share: A Comprehensive Approach to Tracing and Systematically Eliminating Flash in Injection M

In injection molding production, flash is one of the most "stubborn" defects – it not only leads ...

News2026-07-23

Cross-Machine Speed Parameter Adaptation: Precise Control from "Set Value" to "Dynami

This study addresses frequent issue of uneven filling, flash, or material shortages caused by direct...

News2026-07-22



Introduction to Injection Mold Classification and Design Key Points

Injection molds, also known as plastic injection molds, are production tools used for repetitive, hi...

News2026-07-21



Daily Share: A Comprehensive Solution and Zero-Residue Control Strategy for Injection Molding Gate R

In injection molding production, gate residue is an "invisible assembly killer"—although it doesn...

News2026-07-21



Three gate schemes, 30% yield difference! Practical comparison of gate selection for long, rectangul

In die-casting mold design, gate location determines 90% of final yield rate, including porosity, co...

News2026-07-20



Design of Injection Mold for Smoke Alarm Housing Based on CAE Optimization

Abstract: Addressing challenges in mold design for smoke alarm plastic parts, such as difficulties i...

News2026-07-20