News
Only after injection molding tool has been accepted for these steps can mold be shipped
First, appearance, size, and fit of molded products
1. Defects are not allowed on the surface of pro...
News2019-08-16
Car glove box shell mold design analysis/enhanced grade PA66 + GF30%
In this article, product to be analyzed is glove box casing of a car. Material is reinforced grade P...
News2019-08-14
Analysis and elimination of gas mark in plastic products to help you make accurate judgments
Gas mark is a quality defect that is easy to produce and difficult to eliminate. Gas mark not only...
News2019-08-13
Injection molding experience sharing | What is flow marks?
Injection moulding process is a complex process involving plastic engineering materials, molds, inj...
News2019-08-07
List of technical points for production, R&D and quality control of plastic toys
Whether it is a toy designer or a toy company, in order to truly professionally engage in toy indust...
News2019-08-05
High temperature operation: key considerations for hot runner systems in hot runner mold
Choice of gate type and location may be one of the most important decisions you make during injectio...
News2019-08-03
Several common fault solutions for structural form and processing of injection moulding
Structural form and processing quality of injection moulding directly affect quality and production...
News2019-07-31
Characteristics of transparent raw materials commonly used in plastics and injection manufacturing p
Due to advantages of light weight, good toughness, easy molding, and low cost, plastics are increasi...
News2019-07-29
5G commercial and home appliance production growth brings new hopes - Current situation and developm
In 2018, China's mold steel output was about 2.362 million tons. Among them, auto molding consumes ...
News2019-07-26
How does mold go from design to finished product? - We must know these processing steps!
Molding design is an important part of large-scale new product development process. Since product ...
News2019-07-24