Design of injection mould for front shell of temperature controller

Product diagram of front shell of temperature controller is shown in Figure 1. Maximum size of produ...

News2022-05-25



11 kinds of surface defects of TPE injection parts and their solutions

One of reasons for surface problems of TPE injection molded parts is poor quality of raw materials, ...

News2022-05-24



How to quickly solve 9 kinds of injection molding machine failures

Before repairing injection molding machine, it is necessary to fully understand working principle of...

News2022-05-23



Multi-cylinder insert filling process and design of uniform vibration material device

【Abstract】Original process of upper and lower half shells is to put hundreds of cylindrical insert...

News2022-05-20



Plastic traceability of scientific injection 2-Past and present of cellulose

Cellulose chemistry is one of main foundations from which polymer industry was born. But initially n...

News2022-05-19

Common plastic properties

Mastering properties of various plastics is basic skill of making plastics. If you have a solid basi...

News2022-05-18



Injection molding machine clamping parameters setting

1. Start clamping pressure: Initial setting value is 25. When pressure is too small and speed is too...

News2022-05-17



Design of side parting core-pulling mechanism-motorized lateral parting core-pulling mechanism

There are many forms of motorized lateral parting core-pulling mechanisms, most of which use incline...

News2022-05-16



Misunderstandings and Improvements of First Piece Inspection in Injection Molding Factory

In design and production process of any product, there are often design changes, process changes, pr...

News2022-05-15



Injection molding machine maintenance manual: solutions to 14 problems in clamping part

Approach:
Check safety door front travel switch and repair it.
Check 24V5A power supply in electrica...

News2022-05-14