PC/ABS common problems and solutions

PC/ABS, polycarbonate and acrylonitrile-butadiene-styrene copolymers and mixtures, are thermoplastic...

News2022-05-27



To prevent screw of injection molding machine from slipping, we must consider these aspects!

For hygroscopic materials (such as nylon), high resin moisture content can also cause screw slip. Im...

News2022-05-26



Design of injection mould for front shell of temperature controller

Product diagram of front shell of temperature controller is shown in Figure 1. Maximum size of produ...

News2022-05-25



11 kinds of surface defects of TPE injection parts and their solutions

One of reasons for surface problems of TPE injection molded parts is poor quality of raw materials, ...

News2022-05-24



How to quickly solve 9 kinds of injection molding machine failures

Before repairing injection molding machine, it is necessary to fully understand working principle of...

News2022-05-23

Multi-cylinder insert filling process and design of uniform vibration material device

【Abstract】Original process of upper and lower half shells is to put hundreds of cylindrical insert...

News2022-05-20



Plastic traceability of scientific injection 2-Past and present of cellulose

Cellulose chemistry is one of main foundations from which polymer industry was born. But initially n...

News2022-05-19



Common plastic properties

Mastering properties of various plastics is basic skill of making plastics. If you have a solid basi...

News2022-05-18



Injection molding machine clamping parameters setting

1. Start clamping pressure: Initial setting value is 25. When pressure is too small and speed is too...

News2022-05-17



Design of side parting core-pulling mechanism-motorized lateral parting core-pulling mechanism

There are many forms of motorized lateral parting core-pulling mechanisms, most of which use incline...

News2022-05-16