Selection of mold temperature during plastic injection molding

Mold temperature refers to surface temperature of mold cavity in contact with product. It has a grea...

News2022-06-24



What problems should we pay attention to in transparent plastic injection molding?

Due to high light transmittance of transparent plastics, surface quality of plastic products must be...

News2022-06-23



Design points of injection mold for forehead temperature gun bracket

Forehead temperature gun bracket belongs to PCB bracket inside portable forehead temperature measuri...

News2022-06-22



Application of Cavity Pressure Sensor - Automotive Lamp Injection Molding

Cavity pressure sensors have been in injection molding manufacturing for over 30 years. There are va...

News2022-06-21



Causes and solutions of warping deformation of plastic products

Warpage deformation is one of common defects in injection molding of thin-shell plastic parts, becau...

News2022-06-20

Research on process parameters for inhibiting shrinkage of plastic parts of polyoxymethylene gears

Gear is shown in Figure 1. Number of teeth z is 33, modulus m is 1.48 mm, pressure angle α is 29°,...

News2022-06-17



Summary of 19 plastic connection methods, mechanical design engineers must know

Plastics are widely used in medical devices, automobiles and daily products because of their light w...

News2022-06-16



Injection product defect|bubble

Bubble refers to slow cooling of center of wall thickness of product, rapid cooling and shrinkage of...

News2022-06-15



How to calculate production capacity of injection molding factory

Production capacity (capacity) is an important issue for all businesses and at all levels of busines...

News2022-06-14



Concise Handbook of General Engineering Plastics

Materials with medium comprehensive mechanical properties-general engineering plastics refer to thos...

News2022-06-13