Analysis of four reasons for insufficient filling of injection products

Inaccurate feeding measurement or abnormal feeding control system operation, abnormal injection cycl...

News2021-08-30



Design of Injection Mould with Side Core-pulling for Decorative Cover

[Abstract] Material, structure and molding process of decorative cover are analyzed, lateral core pu...

News2021-08-26



Improving method of injection molding plastic parts material flower

Silver streaks (material flowers). All kinds of silver threads are produced from volatiles ejected ...

News2021-08-25



Application of black masterbatch in plastic products

In molding and processing of plastic products, almost everyone has used black masterbatch. It is use...

News2021-08-24



Design of Injection Mould for Lid of Food Preservation Bucket

【Abstract】According to structural characteristics of plastic part, mold structure and molding proc...

News2021-08-23

Analysis and treatment of common failures in plastic electroplating

1. Surface of parts cannot be plated with copper layer; cause of this type of failure is generally c...

News2021-08-20



Plastic modification methods and technical parameters

Its function is to have good compatibility between filler and carrier tree, melting point and melt v...

News2021-08-19



Structure improvement of back cover mould of blood glucose meter

【Abstract】After fully evaluating function of back cover of blood glucose meter, we have carefully ...

News2021-08-17



Plastic shrinkage

Shrinkage control of PP plastic is an important aspect of PP modification, good shrinkage control/co...

News2021-08-16



New injection molding machine debugging steps and precautions

Small machine is integral and does not need to be disassembled. When lifting, mold adjustment should...

News2021-08-13