Four measures to reduce defects in injection molded products

If quality of product exceeds actual maximum injection quality of injection molding machine, supply...

News2021-07-01



Automotive mold design

Plastic part is a certain automobile cable, material is POM, black, one mold with two cavities, and ...

News2021-06-30



How to shorten injection cycle?

In this increasingly competitive business society, improving production efficiency is an issue worth...

News2021-06-29



Gating plan and mold flow analysis of automobile inner and outer parts

In recent years, due to rapid development of automobile industry and trend of lightweight automobile...

News2021-06-28



Design essentials of injection mould for front and rear shells of law enforcement recorder

Product diagram of front and rear housings of law enforcement recorder is shown in Figure 1. Maximum...

News2021-06-27

Introduction to Injection Compression Molding Technology

Compared with traditional injection molding process, main feature of injection compression molding i...

News2021-06-26



PS material basic introduction general purpose polystyrene

PS (polystyrene series plastic) refers to a type of plastic that includes styrene-based in macromole...

News2021-06-25



Two-color bottle cap-cubic mold-unparalleled technical advantages

Cubic mold has an absolute advantage: in the case of same mold installation area, double number of c...

News2021-06-24



What caused rupture of Corinth pillar?

In design of toggle lever type, rigidity of system must be considered. Because toggle lever type ge...

News2021-06-23



Method of improving floating fiber during test of injection molded products

When mold was tested, each mechanism was basically operating normally, but there were serious appear...

News2021-06-22