Design of Hot Runner System for Multi-cavity Injection Mould

[Abstract] Structural characteristics of manifold of multi-cavity hot runner assembly are introduced...

News2021-11-25



Design points of gating system-gate

Gate is a section of material flow channel with a very short length and a very narrow cross section ...

News2021-11-24



Talk about fine maintenance of hydraulic system of injection molding machine

Hydraulic drive of injection molding machine uses hydraulic oil as working medium, uses pressure ene...

News2021-11-23



Design of injection mould for left and right armrest insert

Left and right armrests are important parts of a treatment chair. Product diagram is shown in Figure...

News2021-11-22



What problems should be paid attention to when injection molding of polysulfone PSU products

Polysulfone (PSU, also known as PSF) is a high-temperature resistant, high-strength thermoplastic en...

News2021-11-21

Nitrogen gas spring structure/use/selection-data collection

Nitrogen gas spring for molds (referred to as die gas spring or nitrogen gas spring or nitrogen cyli...

News2021-11-20



Information channel monitor body injection mold design

Main product of information channel monitor is shown in Figure 1. Maximum size of product is 168.00 ...

News2021-11-19



Basic parameters and model representation of injection molding machine

Basic parameters of injection molding machine can better reflect size of injection molded product, f...

News2021-11-18



Experimental Research and Parameter Optimization of Slow Wire Cutting SKD11

SKD11 steel has excellent properties such as high strength, high hardness, and high wear resistance,...

News2021-11-17



Selection and installation of injection mold pressure sensor

Pressure sensor can be installed in the nozzle of injection molding machine, hot runner system, cold...

News2021-11-16