Application of Moldflow in hot runner system

Hot runner is a method of heating, so that plastic in entire runner from nozzle of injection machine...

News2021-03-27



Design of injection mould for guide vane of curtain bead automatic machine

When designing an injection mold, demolding method affects mold structure. Main manifestation is tha...

News2021-03-26



How many of these injection molding machines have mold opening failures?

1. Injection molding machine can't open mold again. There is pressure, speed, oil to cylinder, and ...

News2021-03-25



Gas-assisted injection mold design should consider impact on process parameters

Technical characteristics of gas-assisted injection moulding
(1) Design of mold cavity should try to...

News2021-03-24



Warping deformation control of automobile water chamber based on pre-deformation

Plastics are used more and more widely in automobiles, mainly including interior parts, exterior par...

News2021-03-23

Casket quick-change injection mold design

【Abstract】With increasing competition in the market, replacement of plastic products is getting fa...

News2021-03-22



Design of Injection Mold for Coil Frame

Figure 1 shows coil bobbin used for winding, which is molded with high-strength and high-rigidity PC...

News2021-03-20



Structural characteristics and maintenance analysis of hydraulic system and cylinder of injection mo

Equipment that uses plastic molding molds to make thermosetting plastics or thermoplastics into plas...

News2021-03-19



3D design of injection mould for instrument movement bracket

Instrument core bracket is key support part of PCB board of wave soldering equipment control system....

News2021-03-18



Mould replacement instruction book

According to production plan of workshop, make preparations before changing mold.
1. Put on a safety...

News2021-03-16