Three common defects in polyphenylene sulfide injection molding, how to prescribe right medicine

Polyphenylene sulfide is a thermoplastic engineering plastic with a phenylsulfide group on main cha...

News2021-09-18



Design of Injection Mold for Irradiation Lamp Frame

Product of irradiation lamp holder is shown in Figure 1. Maximum size of product is 98.30 mm * 70.0...

News2021-09-17



Design points of injection mold positioning system

Problem of guiding and positioning is repeated staggered actions when injection mold is closed and o...

News2021-09-16



Design of Injection Mould for 135° Elbow Pipe of Injection Molding Machine

Abstract A 2-cavity two-plate mold was designed for injection molding of plastic parts of 135° elbo...

News2021-09-15



Heat treatment process of plastic mold parts

Different types of steel are used as plastic molds, their chemical composition and mechanical proper...

News2021-09-14

Hot runner injection mold design for paper holder

Paper holder is an important part of shell of a certain Japanese brand printer. Product picture is s...

News2021-09-13



The only way to start injection molding machine!

Irregular start-up process of injection molding machine will cause quality degradation, poor mass pr...

News2021-09-10



10 classic bolt-proof designs!

Once bolt connection in mechanical equipment is loosened, it will cause bolt to fall off and cause m...

News2021-09-09



Design of Injection Mould for Shell of Juicer

【Abstract】According to structural characteristics of juicer shell and technical requirements that ...

News2021-09-08



Quality standards for conventional injection molded parts

This standard mainly stipulates inspection and test methods for various plastic products produced by...

News2021-09-07