Do you know open loop and closed loop of an injection molding machine?

Injection molding control system is a cyclic process, including a set of preset programs, and will r...

News2021-11-04



Design requirements for automotive connectors

In driving of car, various parts of car must work, and various parts must be closely coordinated, an...

News2021-11-03



22 heat treatment problems that are seriously misled

It is often encountered that hardness value of entrusted heat treatment product can only be at a cer...

News2021-11-02



Design of Cooling Channel for Automobile Injection Mould

In design practice, different customers have different requirements for cooling system design. Desig...

News2021-11-01



Discussion on relationship between plastic product design and molding yield

Plastic is everywhere in our lives. In our daily life, more than 60% of daily necessities are made o...

News2021-10-29

Four major developments of two-component injection molding technology and key points of future techn

Two-color injection molding refers to a molding process in which two different materials are injecte...

News2021-10-28



Possible failures and diagnosis steps of hydraulic system of injection molding machine

When using an injection molding machine, possible failures of hydraulic system of injection molding ...

News2021-10-27



Design of Injection Mould for Automatic De-threading of Double-threaded Nut

Product diagram of double-threaded nut is shown in Figure 1. Maximum size of product is 29.00 mm * ...

News2021-10-26



Reverse warpage and solve warpage

One of the biggest challenges in molding process of thick-walled plastic products is problem of dime...

News2021-10-25



Latent glue feeding method in injection mould and solution to problem of dragging glue powder

【Abstract】Latent glue feeding is a commonly used method of glue feeding in injection moulds. Desig...

News2021-10-22