News
Study on problem of poor exhaust in injection molding of control handle
Structure of control handle is shown in Figure 1. Material is PA66, which is a typical thick-walled ...
News2026-03-23
A Practical Guide to Injection Molding Process in Plastic Part Development: Refined Management from
Plastic part development is a systematic engineering project integrating structural design, mold man...
News2026-03-21
PART 05: Relationship Between Injection Speed and Pressure: An In-Depth Analysis of Principles of Sp
Part One: Definitions, Functions, and Coupling Principles of Injection Pressure and Injection Speed
...
News2026-03-20
PART 04: How should barrel temperature be set? This article will guide you through front, middle, an
Barrel temperature is a crucial setting parameter among five essential elements of injection molding...
News2026-03-19
Injection Mold Design: A Comprehensive Analysis of Hot Runner Systems
Hot runner technology is a revolutionary technology that has completely changed face of modern injec...
News2026-03-18
Analysis and Optimization of Injection Molding Process for Automotive Tailgate Handles Based on Mold
Figure 1 shows a 3D model of an automotive tailgate handle. Surfaces A and B are appearance surfaces...
News2026-03-18
A Practical Guide & Injection Mold Design Knowledge Summary
1.1 Qualified product images
1.1.1 Good Product Structure
Product design should minimize unnecessary...
News2026-03-17
Analysis of Causes of Shrinkage Cavities at Engine Hood Support and Optimization Design of Mold
Abstract: This paper introduces structural characteristics and defect forms of automotive engine hoo...
News2026-03-16
Mold Flow Analysis in Practice: Single-Point vs. Two-Point Gate – Choosing Optimal Solution?
In actual injection molding production, gate design is one of key factors affecting product quality,...
News2026-03-16
Design Details of Lifter Mechanisms in Injection Molds
In injection mold design, lifter mechanism is core structure for resolving issues related to underc...
News2026-03-14