Injection molding machine computer common fault diagnosis and troubleshooting alarm information caus

Injection molding machine computer common fault diagnosis and troubleshooting alarm information caus...

News2025-06-26



Solution to product defects in injection molding machines

1) Principle of EDM, EDM is a thermal processing method that uses electrical energy to convert into ...

News2025-06-25



Impact of bio-based and recycled plastics on molds

In the field of plastic processing, bio-based and recycled resins are increasingly used, and their p...

News2025-06-24



Die-casting process and mold design for rear end cover of automobile compressor

A compressor end cover casting is shown in Figure 1. Material is ADC12, basic wall thickness is 4 mm...

News2025-06-23



Answers to injection molding technical problems

"Answers to Technical Problems in Injection Molding and Injection Molding Machine Use"
1. Reasons ...

News2025-06-23

Mold support system design pit avoidance manual (support column/ejector block/spring hole/avoidance)

1. Layout points
Triangle principle: Triangle distribution at four corners and center of mold core (...

News2025-06-21



Common plastic material density/mold temperature/material temperature parameters


Material name Calcium carbonate Carbon fiber Glass fiber Talc Density Mold temperature Molding temp...

News2025-06-20



Application of MoldFlow in connector product development

High density and low spacing characteristics of communication connectors determine thin walls, long ...

News2025-06-19



Design of injection mold for automobile headlight decoration

As shown in Figure 1, decoration of a certain automobile headlight (right) has a complex structure, ...

News2025-06-18



Discussion on several methods of automatic cutting off of condensate in side gate pouring system

Using differential ejection to cut off condensate in side gate pouring system means staggering eject...

News2025-06-17