News
Performance and use of plastic raw materials
Introduction to plastic materials----
1 Classification of commonly used raw materials for plastics
2...
News2024-12-31
Effect of Mn Content on Microstructure and Properties of Al-Mn Die Casting Alloy
With rapid development of 3C industry, demand for aluminum alloy materials in the global market cont...
News2024-12-30
Design of injection mold for transparent plastic parts based on two pushes
Structure of plastic part is shown in Figure 1. It is annular as a whole, with a protruding handle o...
News2024-12-30
A brief introduction to current status and development trend of die-casting aluminum alloy industry
Pressure casting (referred to as die-casting) is to fill die-casting cavity (die-casting mold) with ...
News2024-12-28
Technical points for injection molding of transparent products.
Due to high light transmittance of transparent plastics, it is inevitable that surface quality of pl...
News2024-12-28
Influence of external factors on quality of die castings in die casting production and countermeasur
With rapid development of modern industry, die casting technology has been widely used in various fi...
News2024-12-27
Injection mold 3D design sequence and design key points summary
Design points: can extend but not stretch, can stretch but not connect, can be flat but not beveled,...
News2024-12-27
Effect of heat treatment on structure and mechanical properties of die-cast AlSi10MnMg shock tower
As a key load-bearing component connecting car body and chassis, shock tower is mainly used to absor...
News2024-12-26
Two-color mold design information
2. Improve feel. Some handheld products require use of Rubber on handheld part, which will make feel...
News2024-12-26
Analysis of exhaust duct deceleration structure of aluminum alloy die-casting parts
Aluminum alloy die-casting has advantages of high dimensional accuracy, good appearance quality, and...
News2024-12-24