News

Analysis and Improvement of Injection Molding Part Defects - Cold Slug
Cold slug is cold slug generated during melt injection molding process that enters mold cavity, caus...
News2024-12-08

Technology Frontier丨Dynamic Analysis of Packing Force of Die Castings
During solidification process of die casting, shrinkage of alloy generates a tightening force on mol...
News2024-12-07

Understanding physical property table of injection molding materials and setting process parameters
To understand physical property table of plastics, you first need to understand main physical and ch...
News2024-12-07

Technology Frontier | Mold Optimization Design to Solve Leakage Defects of Aluminum Alloy Die Castin
Taking an automobile engine crankcase as an example, this paper introduces location where leakage oc...
News2024-12-06

Mold design experience (serial 2)
31. After mold has been used for a period of time, it needs to be repaired. During process of repair...
News2024-12-06

Technology Frontier丨Mold Design of Aluminum Alloy Die-casting Shell
Die-casting is widely used in automobiles, 3C products, hardware parts, etc. due to its advantages o...
News2024-12-05

Design of injection mold for refrigerator zero-degree chamber card strip
Figure 1 shows refrigerator zero-degree chamber card strip, which is made of high-impact polystyrene...
News2024-12-05

DuoCast die-casting machine technology - a single die-casting machine enables simultaneous productio
Die-casting industry is currently undergoing a shift toward electric vehicles, and at the same time,...
News2024-12-04

The most comprehensive introduction to injection molding screws
Feeding section L1
Function: Responsible for transportation and preheating of plastic; ensuring that...
News2024-12-04

Types of aluminum alloy anodic oxidation defects
2. Oxidation surface treatment products have the most surface defects in production site, and scrap ...
News2024-12-03