Aluminum alloy anodizing and surface treatment technology

1. Low density
Density of aluminum is about 2.7g/cm3, which is the second lightest metal in metal st...

News2025-02-07



Practical application of Moldflow analysis results

Based on flow balance: If a single gate causes melt flow distance to be too long, pressure loss to b...

News2025-02-07



The world's top ten mold types ranking - Forging die

A die that forms a metal blank into a blank or a product under pressure, including hammer forging di...

News2025-01-23



Effects of Er and Zn on structure and properties of new high-strength die-cast Al-9Si-0.6Fe-0.2-Mn-0

Al-Si alloy has good fluidity, small shrinkage and hot cracking tendency, and is widely used. Pressu...

News2025-01-22



Classic Summary of European and American Automobile Headlight Molds

Injection molds generally have domestic molds and foreign molds. Generally, domestic molds have lowe...

News2025-01-22

Optimization of die-casting process for ultra-thin laptop magnesium alloy shell

Magnesium alloys have advantages of low density, high specific strength and specific stiffness, good...

News2025-01-21



Glove Box Assembly Design Guide

Glove box door: external parts of glove box that can open and close storage function.
Glove box lock...

News2025-01-21



Constitutive equation of superplastic compression deformation of AZ31/AZ61/AZ91 magnesium alloy

Magnesium alloys have been widely used in recent years due to their good dimensional stability, low ...

News2025-01-20



Process method for controlling warping deformation of long glass fiber plastic parts

Figure 1 shows typical structure of instrument panel skeleton, with a cross-section approximately U-...

News2025-01-20



Using thermal stress field simulation to estimate life of local areas of die-casting molds

Die-casting molds work under high temperatures and high pressures, have high requirements for therma...

News2025-01-18