News
Constitutive equation of superplastic compression deformation of AZ31/AZ61/AZ91 magnesium alloy
Magnesium alloys have been widely used in recent years due to their good dimensional stability, low ...
News2025-01-20
Process method for controlling warping deformation of long glass fiber plastic parts
Figure 1 shows typical structure of instrument panel skeleton, with a cross-section approximately U-...
News2025-01-20
Using thermal stress field simulation to estimate life of local areas of die-casting molds
Die-casting molds work under high temperatures and high pressures, have high requirements for therma...
News2025-01-18
Internal stress and residual stress of injection molded products
In injection molding, it is often mentioned that product has internal stress, residual stress and it...
News2025-01-18
Structural Design Guidelines for Electronically Controlled Die Casting Products - Wall Thickness and
Understanding customer and part requirements is key to achieving a design that maximizes part perfor...
News2025-01-17
N93 mobile phone bottom case injection mold design key points
N93 mobile phone bottom case product is shown in Figure 1. Maximum outer dimensions of product are 9...
News2025-01-17
A process optimization of low-pressure casting aluminum alloy cover plate casting for GIS
Aluminum alloy castings have good surface gloss, corrosion resistance, low density, high specific st...
News2025-01-16
Uncovering mysterious connection between Moldflow results and molding defects
Moldflow results:
Filling time results: If there are still some areas that are not filled with plast...
News2025-01-16
Effect of Ultrasonic Power on Properties of Vacuum Differential Pressure Casting ZL114A Aluminum All
ZL114A alloy is widely used in production of large thin-walled complex aluminum alloy castings in av...
News2025-01-15
The world's top ten mold types ranking-Plastic mold
A mold that allows molten plastic raw materials to fill cavity under pressure and solidify into prod...
News2025-01-15