Development of Die-Casting Process for Front Housing of New Energy Vehicles

Abstract: For a die-cast front housing of a new energy vehicle, numerical simulation was applied to ...

News2026-08-17



Injection Mold Design Specification

1 Scope
This standard specifies design requirements and methods for each system in injection mold de...

News2026-08-17



Design of Mold for Inclined Pipe Inlet Gas Chamber in Automotive Heat Exchange System

With rapid development and fierce competition in automotive industry, automobiles have become an ind...

News2026-08-17



What are differences between steam traceless high-gloss injection molding and traditional injection

How to produce shell products with no melting marks, no flow marks, no streamlines, no sink marks, a...

News2026-08-16



How to solve shrinkage and warpage? Just read this article!

Plastic injection molding will shrink inherently because density of polymer changes when process tem...

News2026-08-15

A Detailed Explanation of Plastic Material Flash Value: Quality Control from Theory to Practice

In injection molding industry, flash (also known as burr, burr, or burr) is a common and frustrating...

News2026-08-14



A Comprehensive Analysis of Injection Molding Process: From Filling to Demolding, Four Stages to Dee

Quality of injection molded products is determined by four continuous and interconnected stages in m...

News2026-08-13



Design of mold structure, these characteristics can not be ignored~

Air extraction hole design for vacuum forming is the key to mold design. Air extraction hole should ...

News2026-08-12



Design of Hot Runner Mold with Multi-Lifters for Automotive Glove Box Body

Automobile glove box is a challenging component in automotive interior design. Its main components i...

News2026-08-12



What is complete mold design process?

Molds are developing rapidly in production and daily life. Many industries use molds to process prod...

News2026-08-11