News
Injection Mold Gate Design Q&A Notes
Q: What is a gate in an injection mold? What role does it play in injection molding process?
A: A ga...
News2026-11-07
Plastics Materials (Part 10): In-depth Analysis of POM (Polyoxymethylene)
POM (Polyoxymethylene), commonly known as "acetal," is the most rigid and wear-resistant of five m...
News2026-11-07
Mold Temperature Controller Selection
Mold Temperature Controller Explanation: A mold temperature controller is an industrial device used ...
News2026-11-06
Injection Molding Core Process Parameter Setting and Optimization Logic
Gate Section (First Section): A slower speed is recommended to prevent "jetting marks" caused by m...
News2026-11-06
Plastic Materials (Part 9): In-depth Analysis of PEHD & PMMA
PEHD (High-Density Polyethylene) and PMMA (Polymethyl Methacrylate/Acrylic).
PEHD (HDPE) is the high...
News2026-11-05
Six Common Injection Molding Machine Faults and Troubleshooting Methods (Workshop Practical Solution
These are categorized into six main types: hydraulic system, injection system, mold clamping system,...
News2026-11-04
Types of Hot Runner Systems
Core classification of hot runner systems is based on valve control method at gate, mainly divided i...
News2026-11-04
Recurring Shrinkage Marks in Thick-Walled Automotive Parts? A Full-Chain Solution from "Materia
Last week, I spent two full days in automotive door panel mold workshop—client urgently needed a ba...
News2026-11-04
Angled Slider Design
Since undercut surface of finished product is inclined, not at a 90° angle to mold opening directio...
News2026-11-03
From ABS to PBT: A Comprehensive Analysis of Properties of 6 Commonly Used Plastics, From Material S
(1) Thermoplastic materials: After heating, they become soft and flowable resins. This process of co...
News2026-11-03