Introduction to Injection Mold Classification and Design Key Points

Injection molds, also known as plastic injection molds, are production tools used for repetitive, hi...

News2026-07-21



Daily Share: A Comprehensive Solution and Zero-Residue Control Strategy for Injection Molding Gate R

In injection molding production, gate residue is an "invisible assembly killer"—although it doesn...

News2026-07-21



Three gate schemes, 30% yield difference! Practical comparison of gate selection for long, rectangul

In die-casting mold design, gate location determines 90% of final yield rate, including porosity, co...

News2026-07-20



Design of Injection Mold for Smoke Alarm Housing Based on CAE Optimization

Abstract: Addressing challenges in mold design for smoke alarm plastic parts, such as difficulties i...

News2026-07-20



Daily Share: A Comprehensive Guide to Diagnosing and Resolving Short Shots in Injection Molding

In injection molding production, short shots are the most "basic yet fatal" defect–directly leadi...

News2026-07-18

Daily Share: A Comprehensive Solution and Dual Improvement Strategy for Strength and Appearance of W

Among injection molded part defects, weld lines are a classic example of a "double whammy" – they...

News2026-07-17



When designing injection molded parts, pay attention to these points

Choice of plastic material plays a crucial role in product's appearance, and different plastic mate...

News2026-07-16



Design of a Cold Runner Two-Plate Injection Mold for Reflector Base Shell of Front Light Module of a

Abstract: A cold runner two-platen family injection mold was designed for injection molding of refle...

News2026-07-16



Injection Molding Machine Adjustment Case Study: Solving Product Deformation Problems Caused by Shor

Adjusting injection molding machines is never simply a matter of blindly following parameters and fo...

News2026-07-15



Analysis of Three-Way Joint Structure That Gives Mold Design Experts a Headache!

Having worked in product structure and mold design for many years, I've encountered quite a few dif...

News2026-07-14