Left and right rearview mirror shell injection mold design

Left and right rearview mirror housing products are shown in Figure 1. Left and right plastic parts ...

News2022-05-06



What problems should be paid attention to in injection molding long fiber reinforced plastic LFRT?

Long fiber reinforced thermoplastics (LFRTs) are being used in injection molding applications with h...

News2022-05-05



How to molding wall thickness parts

Shrinkage of plastic parts (surface shrinkage and internal shrinkage) are all defects caused by insu...

News2022-05-04



About Elastomer TPR | TPR FAQ

Answer: Usually oil added to rubber is aromatic oil containing benzene ring, which is toxic. Oil add...

News2022-05-03



You don't necessarily know all these LCP injection molding knowledge!

LCP injection molding, Processing technology of LCP material, liquid crystal polymer, 2.LCP injectio...

News2022-04-30

Design of injection mold for end cover of diagnosis and treatment instrument

Product of end cover of diagnostic instrument is shown in Figure 1. Maximum external dimension of pr...

News2022-04-29



Do you know the three types of centralized lubrication systems for injection molding machines?

Guide sleeve of injection molding machine before and after injection, guide sleeve of tie rod of mov...

News2022-04-28



Teach you a few routines to save money in injection molding process

For an injection molding factory, energy consumption of injection molding process accounts for about...

News2022-04-27



Injection mold design for storage box of central armrest box

Car armrest box is a kind of car accessory installed between two seats, which belongs to car interio...

News2022-04-26



Frequently Asked Questions about Hot Runner System

Problem: Cavity is not filled
Reasons: Melting temperature is too low; injection pressure is too sma...

News2022-04-25