News

Analysis and optimization of injection mold structure based on Moldex 3D and ABAQUS
During injection process, mold is subjected to combined effects of mechanical force and heat transfe...
News2021-03-09

You are not sure about mold runner, maybe you are really out of date!!!
Hot runner molds are widely used in developed countries and regions in the world today. This is main...
News2021-03-08

Key Points of Design of Injection Mold for Modem Bottom Case
A modem is a device for signal conversion between a computer and a telephone line. It consists of a ...
News2021-03-07

Design of Injection Mould for Bumper of Changan Ford
Bumper is one of important parts of car. It is a decorative car exterior part. It not only has decor...
News2021-03-06

Factor analysis of plastic mold cost management
With development and change of society, pressure of cost competition between enterprises is increasi...
News2021-03-05

Design analysis of injection mould for automobile headlight lamp shell
Car lights are mainly used for lighting, which can be said to be eyes of cars. Car lights are collec...
News2021-03-04

Design of Injection Mould for Cream Bottle
With rapid economic development, cosmetics and skin care products have gradually become daily consum...
News2021-03-02

How to improve transparency of plastic products
Because plastic has advantages of light weight, good toughness, easy molding, low cost, etc., so in...
News2021-03-01

7 points that must be considered in plastic injection molding
Setting of injection molding process should consider 7 factors such as shrinkage, fluidity, crystall...
News2021-02-27

16 ways to improve thin-wall injection molding defects
Thin-wall injection molding technology is also called thin-wall plastic injection molding technology...
News2021-02-26