News

Design of Injection Mould for Front and Back Blades of UAV
Civilian propeller drones have taken the world by storm and have been widely used in geological pros...
News2021-02-01

Hot runner system installation method and seven skills to reduce defects in mold processing
Hot runner system is an important part of plastic mold production equipment. Hot runner system gener...
News2021-01-29

Six scientific injection molding process optimization steps!
Purpose of making viscosity curve is to select an appropriate injection speed, which will not cause ...
News2021-01-28

Case sharing: How to use Moldflow to solve defect of easy cracking of steering wheel plastic parts?
This article mainly focuses on research and optimization of defects such as easy cracking and short ...
News2021-01-27

28 questions about plastic processing aids
1. What is a polymer material processing aid? what is function?
Answer: Additives are various auxili...
News2021-01-26

How to use MOLDFLOW mold flow analysis to solve mold problems in connector industry
Abstract: Article discusses problems that easily occur in molding of plastic products in connector, ...
News2021-01-24

Detailed explanation of material surface treatment process
Surface treatment is a process of artificially forming a surface layer on the surface of substrate m...
News2021-01-23

Not many injection mold designers really understand these four concepts
Generally speaking, for crystalline plastics, when processing temperature is higher than its melting...
News2021-01-22

Injection molding process parameters of common plastics
Temperature in brackets is recommended as basic setting value, stroke utilization rate is 35% and 65...
News2021-01-21

What problems should be paid attention to when using thimble oil?
During injection molding process of thimble, thimble and thimble hole rub against each other. If thi...
News2021-01-16