Injection mold design for storage box of central armrest box

Car armrest box is a kind of car accessory installed between two seats, which belongs to car interio...

News2022-04-26



Frequently Asked Questions about Hot Runner System

Problem: Cavity is not filled
Reasons: Melting temperature is too low; injection pressure is too sma...

News2022-04-25



What issues should be paid attention to when producing PC polycarbonate products?

PC has excellent performance, high transparency, good impact toughness, creep resistance, and wide o...

News2022-04-24



6 injection molding machine failure repair steps, quickly implement

Both imported and domestic injection molding machines have following characteristics:
Injection mold...

News2022-04-23



Usage of injection speed and precautions for machine adjustment!

Proportional control of injection speed has been widely adopted by injection molding machine manufac...

News2022-04-22

Mould Design of Decorative Parts of Vacuum Cleaner Panel

Small buckle structure is shown in Figure 1. Material is PP, and there is a long inner hole on the s...

News2022-04-21



Using small gates for injection molding has so many advantages!

Gate is a very critical section of material flow channel in gating system. Except for main runner ty...

News2022-04-20



Design of Parting Mechanism in Injection Mould for Automobile Decoration Strip

With development of automobile industry, consumers have higher and higher requirements for appearanc...

News2022-04-19



Design of injection mold for light-transmitting display area of air-conditioning panel

Inner panel of air conditioner is main appearance surface of the whole machine, and generally has a ...

News2022-04-18



An article to understand fountain flow effect of plastic!

It is well known that molten plastic flows in mold in the form of a fountain during injection moldin...

News2022-04-17