Common plastic properties

Mastering properties of various plastics is basic skill of making plastics. If you have a solid basi...

News2022-05-18



Injection molding machine clamping parameters setting

1. Start clamping pressure: Initial setting value is 25. When pressure is too small and speed is too...

News2022-05-17



Design of side parting core-pulling mechanism-motorized lateral parting core-pulling mechanism

There are many forms of motorized lateral parting core-pulling mechanisms, most of which use incline...

News2022-05-16



Misunderstandings and Improvements of First Piece Inspection in Injection Molding Factory

In design and production process of any product, there are often design changes, process changes, pr...

News2022-05-15



Injection molding machine maintenance manual: solutions to 14 problems in clamping part

Approach:
Check safety door front travel switch and repair it.
Check 24V5A power supply in electrica...

News2022-05-14

Several methods to solve stability of transparent plastics

Because plastic has light weight, good toughness and easy molding. Due to advantages of low cost and...

News2022-05-13



Application of 3R Fixture Process Benchmark System

3R is abbreviation for the three principles of reducing, reusing and recycling. It was proposed by B...

News2022-05-12



Relationship between tolerances, shrinkage and molding strategies for injection molded products

"Just make the product."
I'm sure everyone has heard this saying? But things are not so simple. D...

News2022-05-11



Several factors affecting service life of plasticizing components of injection molding machines

When injection molding machine is working, plasticizing component is like wheel of a motor vehicle. ...

News2022-05-10



Drip pot + tee + handle injection mold design + 3d

Drip pot + tee + handle is an infusion product in the category of medical device products. Drip pot ...

News2022-05-09