Talking about plastic molding: the essentials and problems of plastic injection molding

1 Seven Elements of Plastic Forming
A pressure B speed C time D temperature E measurement F raw mat...

News2023-01-07



Polyethylene injection molding process conditions and performance analysis of polyoxymethylene

Polyethylene injection molding process conditions
01 Barrel temperature
Barrel temperature during P...

News2023-01-05



Design of injection mold for toy car casing

As shown in Figure 1, front features of plastic part have 1 rectangular side hole, 1 deep rib, 2 sid...

News2023-01-04



Some related data for injection molding

Due to complexity of injection molding machine processing, various small problems are often encounte...

News2023-01-03



Key points for setting operating conditions at each stage in injection molding

(1) Gradually heat up from the first stage (feeding place) to third stage (before nozzle), temperatu...

News2022-12-31

How to set reasonable injection process parameters?

Debugging of injection molding machine refers to continuous adjustment of various parameters of inj...

News2022-12-30



How to use sensors to conduct an all-round medical examination for injection molding manufacturing -

Whether in automotive industry, medical technology or electronics industry - zero-defect production ...

News2022-12-29



Correlation and difference between plastic machine process and mold flow analysis data

Abstract: This paper focuses on analysis of Moldflow software, compares data analyzed by software wi...

News2022-12-28



Master melt temperature through plasticization analysis

Plastic temperature control in injection molding usually uses rotation of screw and heating plate on...

News2022-12-27



Flip-chip injection mold design for searchlight cover

Searchlight cover product is shown in Figure 1. Maximum external dimension of product is 362.40 mm *...

News2022-12-24