Three factors that should be considered in terms of materials in injection molding

1 Shrinkage rate
Factors affecting shrinkage of thermoplastic molding are as follows:
1.1 Plastic Va...

News2022-06-28



In-depth analysis of every step of injection mold from design to production of finished products.

Mold design is an important link in development process of large-scale products. Because product and...

News2022-06-27



What should I pay attention to when operating injection molding machine?

1. Be sure to turn off power switch of motor and electric heating before powering on.
2. Check wheth...

News2022-06-25



Selection of mold temperature during plastic injection molding

Mold temperature refers to surface temperature of mold cavity in contact with product. It has a grea...

News2022-06-24



What problems should we pay attention to in transparent plastic injection molding?

Due to high light transmittance of transparent plastics, surface quality of plastic products must be...

News2022-06-23

Design points of injection mold for forehead temperature gun bracket

Forehead temperature gun bracket belongs to PCB bracket inside portable forehead temperature measuri...

News2022-06-22



Application of Cavity Pressure Sensor - Automotive Lamp Injection Molding

Cavity pressure sensors have been in injection molding manufacturing for over 30 years. There are va...

News2022-06-21



Causes and solutions of warping deformation of plastic products

Warpage deformation is one of common defects in injection molding of thin-shell plastic parts, becau...

News2022-06-20



Research on process parameters for inhibiting shrinkage of plastic parts of polyoxymethylene gears

Gear is shown in Figure 1. Number of teeth z is 33, modulus m is 1.48 mm, pressure angle α is 29°,...

News2022-06-17



Summary of 19 plastic connection methods, mechanical design engineers must know

Plastics are widely used in medical devices, automobiles and daily products because of their light w...

News2022-06-16