News

To prevent screw of injection molding machine from slipping, we must consider these aspects!
For hygroscopic materials (such as nylon), high resin moisture content can also cause screw slip. Im...
News2022-05-26

Design of injection mould for front shell of temperature controller
Product diagram of front shell of temperature controller is shown in Figure 1. Maximum size of produ...
News2022-05-25

11 kinds of surface defects of TPE injection parts and their solutions
One of reasons for surface problems of TPE injection molded parts is poor quality of raw materials, ...
News2022-05-24

How to quickly solve 9 kinds of injection molding machine failures
Before repairing injection molding machine, it is necessary to fully understand working principle of...
News2022-05-23

Multi-cylinder insert filling process and design of uniform vibration material device
【Abstract】Original process of upper and lower half shells is to put hundreds of cylindrical insert...
News2022-05-20

Plastic traceability of scientific injection 2-Past and present of cellulose
Cellulose chemistry is one of main foundations from which polymer industry was born. But initially n...
News2022-05-19

Common plastic properties
Mastering properties of various plastics is basic skill of making plastics. If you have a solid basi...
News2022-05-18

Injection molding machine clamping parameters setting
1. Start clamping pressure: Initial setting value is 25. When pressure is too small and speed is too...
News2022-05-17

Design of side parting core-pulling mechanism-motorized lateral parting core-pulling mechanism
There are many forms of motorized lateral parting core-pulling mechanisms, most of which use incline...
News2022-05-16

Misunderstandings and Improvements of First Piece Inspection in Injection Molding Factory
In design and production process of any product, there are often design changes, process changes, pr...
News2022-05-15