Selection of injection speed for plastic parts

Control of injection molding process has a direct impact on final part quality and economics of proc...

News2023-06-08



Design of lifter of mold has been thoroughly completed this time!

Lifter is a common term for mold industry in Pearl River Delta region, which is dominated by Hong K...

News2023-06-07



Analysis and Countermeasures of Poor Gate Cutting

It refers to a phenomenon in which gate connecting molded product, main runner, and branch runner i...

News2023-06-06



Injection process parameters and their adjustment

In filling and holding pressure drop section, cavity pressure increases with time. After filling cav...

News2023-06-05



How does hydraulic system work during injection molding process?

All movements in injection molding process, whether hydraulic or electric, generate pressure. Approp...

News2023-06-02

Structural design considerations for injection-molded containers

Injection molding is to inject molten plastic into a closed mold with a lower temperature through a ...

News2023-06-01



It is very important to master these important parameters that control injection molding process

Property of friction between macromolecules when molten plastic flows is called plastic viscosity. C...

News2023-05-31



Design of Core Pulling Injection Mold in T-shaped Slot

Figure 1 shows a sliding part in an electronic product, which is composed of an iron part and a plas...

News2023-05-30



Important knowledge about "Gas-Assisted Injection Molding"

Gas-Assisted Injection Molding (GRIM) is a new type of injection molding process, which has been wid...

News2023-05-29



What are key points in precision injection molding?

Precision injection molding will be affected by many related factors and environmental conditions, a...

News2023-05-27