Common causes and solutions for misjudgment of plastic product quality

As saying goes: "No one is perfect, no gold is pure, no one is a sage, no one can make mistakes!" ...

News2024-04-18



Die casting production case! Research on vacuum die-casting LED lamp radiator castings

Magnesium alloy has characteristics of high specific strength and specific stiffness, good impact re...

News2024-04-17



Contactor base injection mold design

Base is similar to a semi-enclosed box-shaped piece. Coil is installed inside box surrounded by vert...

News2024-04-17



Analysis and solutions for thermal cracking of die-cast ADC12 aluminum alloy mobile phone middle fra

Abstract: Causes of thermal cracking of middle frame of die-cast ADC12 aluminum alloy mobile phones ...

News2024-04-16



It is recommended to refer to eight aspects when talking about injection molding companies reducing

For an injection molding product factory, injection molding process accounts for approximately 60% o...

News2024-04-16

Design of an aluminum alloy shell die-casting mold

By analyzing structure and formability of shell parts, we focused on detailed analysis and research ...

News2024-04-15



Plastic structure design 5 —hole, thread, and insert design requirements

It is a common method to open holes in plastic parts to connect them with other parts or to increase...

News2024-04-15



Defects and Countermeasures of Low-Pressure Casting of Magnesium Alloy Shells

Magnesium alloy is widely used in the aerospace field due to its light weight and high strength. As ...

News2024-04-12



Injection Mold Gate Design Principles

General flow pattern-fountain-like laminar flow
Features of fountain flow:
1. The fastest flowing ar...

News2024-04-12



Development of multi-cavity die-casting mold for small brackets based on ProCAST software

There are various small brackets in automobile engine, which support various moving functional parts...

News2024-04-11