Formation and elimination of bubbles in injection molded parts

Air bubbles in product during injection molding are a common problem to be solved.
This article desc...

News2023-07-25



Design of typical automatic thread removal injection mold

In plastic parts, many industrial products and civilian products have internal and external thread d...

News2023-07-24



Design of Injection Mold for Storage Rack Accessories

Length of plastic part is 248mm, width is 203mm, wall thickness is 2mm, and material is ABS. ABS is ...

News2023-07-22



How to make a mold flow analysis report for two-color mold products?

How to make a mold flow analysis report for two-color mold products?...

News2023-07-21



Selection of injection pressure and holding pressure during plastic injection molding

Injection molding cycle, also known as molding cycle, refers to time required to complete an injecti...

News2023-07-20

A complete collection of plastic parts design techniques, this is very useful for plastic molds

Plastic parts are structural designs based on industrial modeling. First, check whether there are si...

News2023-07-19



Design of injection mold for door trim panel of SAIC GM

Figure 1 shows interior trim panel of left front door of a certain model. This door panel adopts an ...

News2023-07-17



Introduction to Plastic Gear Injection Molding

Plastic gears are moving toward larger sizes, more complex geometries, and higher strength, with hig...

News2023-07-15



Analysis of principle of plastic flow

Molten thermoplastics exhibit viscoelastic behavior, a combination of flow properties of viscous flu...

News2023-07-14



Necessary Factors for Successful Trial of Die Casting Mold——Application of Mind Map

Development of China's die-casting molds has gone through several stages of growth. The first stage...

News2023-07-13