Design of Injection Mould for Desk Fan Bracket

Stand of desk fan is shown in Figure 1, where A is position of rotating shaft, which is used to asse...

News2022-10-24



Precautions for using ejector pin oil in injection molds

Matching use of ejector pin and cylinder is called ejector pin cylinder assembly, which is a kind ...

News2022-10-22



What factors are affecting your injection molding cycle time?

For those of you in injection molding industry, many of you know an old saying in our industry that ...

News2022-10-21



If temperature is not well controlled, molding process and quality will be greatly affected!

Because sales market has put forward ultra-thin, beautiful and lightweight consumer requirements for...

News2022-10-20



Steel naming convention

Steel is an iron-carbon alloy with a carbon content of 0.0218% to 2.11%. In order to ensure its toug...

News2022-10-19

Do you know design standards of injection molds?

In mold manufacturing, mold exhaust is a very important link. Mold exhaust can represent quality of ...

News2022-10-18



Research on machining chipping of high hardness material edge after quenching

【Abstract】This paper introduces theoretical research, technology development and application of hi...

News2022-10-17



Mould Design of Internal Threaded Plastic Cover

Figure 1 shows plastic cover with internal thread, material is ABS, internal thread specification is...

News2022-10-15



Analysis of key points of injection molding machine management and maintenance

Routine maintenance means that operators of injection molding machine equipment routinely inspect eq...

News2022-10-14



10 things to pay attention to in mold parting process of plastic molds

Note 1 during parting process: shrinkage rate
Shrinkage rate of product determines dimensional accur...

News2022-10-13