News
Plastic structure design 7 - other design requirements
Insertion position is often encountered in design of plastic products. Insertion position is a perfo...
News2024-05-03
Analysis of development status of aluminum alloy die-casting process and mold technology
After the 1990s, China's die-casting industry has achieved amazing development and has developed in...
News2024-04-30
Ultra-detailed analysis and solutions of common defects in PC injection molding
Polycarbonate (PC) is an engineering plastic with excellent performance. It not only has high transp...
News2024-04-30
Application of air-cooled stirring rod rheological die-casting process in high thermal conductivity
As a high-productivity, low-cost near-net-shape process, die-casting is widely used in communication...
News2024-04-28
Design of flip-chip injection mold for new energy vehicle door handle based on CAE technology
Figure 1 shows a door handle of a new energy vehicle. Material is polycarbonate / acrylonitrile-bu...
News2024-04-28
Optimization of automotive oil pump body die-casting process
In order to meet requirements of high air tightness and high strength of automotive aluminum alloy o...
News2024-04-26
Plastic structure design 6 —part gaps, buckles and stops
This article mainly introduces requirements for parts clearance, buckle positions and stops in desig...
News2024-04-25
Improve performance of die-casting molds and extend service life of die-casting molds
Pressure casting (die casting for short) has characteristics of high production efficiency, short pr...
News2024-04-19
Electric vehicle front cover hot runner mold design
Electric vehicle front hood is shown in Figure 1. Average wall thickness is 2.2mm. Outer wall of pla...
News2024-04-19
Automotive light bracket die-casting process analysis and mold design
Structural characteristics of automobile light bracket were analyzed, die-casting process was design...
News2024-04-18