Main points of design of injection mold for flip cover of printer

Printer clamshell product is shown in Figure 1. Maximum external dimensions of product are 197.86 mm...

News2020-08-08



Design of Injection Mould for Emergency Oxygen Switch Shell of Medical Vehicle

Figure 1 shows emergency oxygen switch shell of an ambulance. Plastic part is composed of three par...

News2020-08-07



Numerical simulation analysis and process optimization of high gloss injection molding of complex st

High gloss injection molding is also known as rapid heat cycle molding (RHCM) and steam-assist inj...

News2020-08-06



Examples of design ideas for master mold opening

Generally speaking, to determine whether a product can be mold-opened, one should follow this line o...

News2020-08-05



Research on Processing Technology of Moveable Mold Core of Outer Cover of Automobile Glove Box

Interior of car glove box is used to store items. When glove box is closed, its appearance can be se...

News2020-08-04

Method to improve solution speed based on motion simulation of large injection mold

Under background of increasingly fierce market competition, various plastic products with peculiar ...

News2020-08-03



Mold injection black spot and impurities are always not cleaned up, we tells you truth!

Black spots and impurity defects are the most important factors for rejection rate in normal product...

News2020-07-31



Ten design softwares that every molder should know.

Mechanical design is the first step in mechanical production and the most important factor in dete...

News2020-07-30



Solution of insufficient hardness during die quenching

In production, sometimes there is insufficient hardness after quenching, which is a common defect in...

News2020-07-29



Nine kinds of mold failure solutions!

During injection molding process, gate is stuck in sprue sleeve and is not easy to come out. When mo...

News2020-07-28