Solutions to shrinkage cavities in die castings

Die castings will shrink in volume during solidification process, forming shrinkage cavities and shr...

News2024-07-19



Injection Molding Processing Guidelines | Part Design

Performance of parts made from LNP composites depends on properties of composite, part design and mo...

News2024-07-19



Analysis and discussion on reasonable filling flow state of die casting

Based on undesirable defects that may occur in die casting, ideal filling effect that alloy liquid s...

News2024-07-18



Design of injection mold for internal thread plastic cover

Plastic part structure is shown in Figure 1. Size is φ71 mm*47 mm, with a through hole in the middl...

News2024-07-18



Solutions to shrinkage cavity defects in die-cast front cover

With development of automobile manufacturing industry, requirements for reducing energy consumption ...

News2024-07-17

Really confused: what is roughness 0.8, 1.6, 3.2, 6.3, 12.5?

Do you know why roughness is 0.8, 1.6, 3.2, 6.3, 12.5?
Let's take it slow
 
1. Concept of surface...

News2024-07-17



Formation mechanism of skin layer and pores of die-cast SiC/6061Al composite materials and their inf

Particle-reinforced aluminum matrix composites (PAMCs) have been mainly used in aerospace and milita...

News2024-07-16



Basic Science | Creep Properties of Materials

Regarding creep properties of materials, today I would like to explain it in detail in the form of a...

News2024-07-16



Technology Frontier丨Effect of Heat Treatment on Performance of Magnesium Alloy Die Castings

Mg-Zn-Al-Mn alloy was prepared by die casting process, effects of different heat treatment processes...

News2024-07-15



Principle of using mold ejector pin is a must-know knowledge point!

1) Ejector pin should be arranged so that ejection force is as balanced as possible. Parts with comp...

News2024-07-15