Bow tie flip cover injection mold design

Structure of plastic part is shown in Figure 1. It is used in daily chemical plastic packaging. Uppe...

News2023-12-09



Analysis of examples of imitation failure in die-casting runner design

Abstract: Through analysis of an example of a failed die-casting mold design, key elements that shou...

News2023-12-08



Elastic sleeve molding process analysis and mold design

Structure of elastic sleeve is shown in Figure 1. Material is PC+ABS and shrinkage rate is 0.53% to ...

News2023-12-07



Design of injection mold for nylon elbow joint

Nylon elbow joint has a 2-section elbow structure, material is modified nylon PA6, and shrinkage rat...

News2023-12-06



Injection molding defect form, this is too comprehensive! Please forward to each other

During injection molding process, it is a common phenomenon for products to shrink and dent. Main re...

News2023-12-04

Key Points of Injection Mold Design for Light Guide Column of Medical Therapeutic Instrument

See Figure 1 for light guide column products of medical therapeutic instruments. Maximum dimensions ...

News2023-12-02



How big is role of hot runner, you will know after reading it

Hot runners are already indispensable in injection molding production. For plastic processors, choos...

News2023-11-30



Injection mold exhaust mode

The thinner product, the farther away from gate, opening of exhaust groove becomes particularly imp...

News2023-11-29



Finite element analysis and topology optimization design of fixed mold plate of injection molding ma

With rapid development of China's industrialization process, demand for plastic products has increa...

News2023-11-28



Research on deformation improvement of Gree air conditioner two-color panel in Moldflow simulation a

In recent years, with demand of consumers for personalized appearance, market has increasingly highe...

News2023-11-26