Contactor base injection mold design

Base is similar to a semi-enclosed box-shaped piece. Coil is installed inside box surrounded by vert...

News2024-04-17



Analysis and solutions for thermal cracking of die-cast ADC12 aluminum alloy mobile phone middle fra

Abstract: Causes of thermal cracking of middle frame of die-cast ADC12 aluminum alloy mobile phones ...

News2024-04-16



It is recommended to refer to eight aspects when talking about injection molding companies reducing

For an injection molding product factory, injection molding process accounts for approximately 60% o...

News2024-04-16



Design of an aluminum alloy shell die-casting mold

By analyzing structure and formability of shell parts, we focused on detailed analysis and research ...

News2024-04-15



Plastic structure design 5 —hole, thread, and insert design requirements

It is a common method to open holes in plastic parts to connect them with other parts or to increase...

News2024-04-15

Defects and Countermeasures of Low-Pressure Casting of Magnesium Alloy Shells

Magnesium alloy is widely used in the aerospace field due to its light weight and high strength. As ...

News2024-04-12



Injection Mold Gate Design Principles

General flow pattern-fountain-like laminar flow
Features of fountain flow:
1. The fastest flowing ar...

News2024-04-12



Development of multi-cavity die-casting mold for small brackets based on ProCAST software

There are various small brackets in automobile engine, which support various moving functional parts...

News2024-04-11



Plastic structural design 4 —reinforcement ribs and columns

Reinforcing ribs are an essential feature in design of plastic parts. They are used to increase stre...

News2024-04-11



Design of die-casting mold for new energy vehicle aluminum alloy motor casing based on UG and Anycas

An aluminum alloy motor shell is shown in Figure 1. Material is AlSi12(Fe), shrinkage rate is 0.55%,...

News2024-04-10