News
Research on mechanical properties of high vacuum die-cast shock tower castings
Due to lightweight requirements, aluminum alloys are increasingly used in automotive structural part...
News2025-01-09
The world's top ten mold types ranking-Stamping die
Stamping die, also known as cold stamping die or hardware die, is a special process equipment used t...
News2025-01-09
Effect of Cr on Microstructure and Mechanical Properties of High Vacuum Die Casting AlSi7MgMn
As society pays more attention to energy consumption, lightweight of automobiles has attracted more ...
News2025-01-08
Injection molding upper and lower mold operation guide
In injection molding production, upper and lower mold work is very important. Mold operator or techn...
News2025-01-08
Effect of T5 treatment on performance of aluminum alloy (high vacuum) die castings
Aluminum alloy has characteristics of low density, high specific strength, easy forming and corrosio...
News2025-01-07
Example of Moldflow analysis report for automobile fan cover
Example report describing main analysis results and optimization solutions Moldflow analysis report
...
News2025-01-07
Engine cylinder product review and engine cylinder mold development discussion
Abstract: Through analysis of engine cylinder products and die-casting process parameters, based on ...
News2025-01-06
Automotive injection mold design and mold concept
The most important component of automotive molds is cover mold. This type of mold is mainly a cold s...
News2025-01-06
Study on structural characteristics and post-aging properties of high-pressure cast Al-Si-Cu-Mg-Fe-M
High-pressure casting is widely used due to its ability to produce thin-walled components, high prod...
News2025-01-04
16 Injection Molding Defects and Solutions, Do You Know?
There is a discernible ring around sprue - a center circle if a center gate is used, and a concentri...
News2025-01-04