Effects of Strontium and Titanium on Microstructure and Properties of Rare Earth Modified Die Castin

Research in recent years has shown that mechanical properties of die-cast AZ91 magnesium alloy can b...

News2024-10-24



Design of injection mold for water-based pen holder

As shown in Figure 1, plastic part has a length of 109.00mm, a maximum outer diameter of φ10.20mm, ...

News2024-10-24



Analysis of die-casting mold surface temperature based on numerical simulation

Quality of die-casting parts is closely related to control of die-casting mold surface temperature. ...

News2024-10-23



Application of lateral core pulling technology in plastic mold design and its working principle

In production of modern plastic products, lateral core pulling technology is an integral part of inj...

News2024-10-23



Research on high-pressure casting process of aluminum alloy 9AT transmission main housing

Improving comfort and economy of cars has always been an important goal of automotive industry. As o...

News2024-10-22

Relationship between plastic products and demoulding angle

Demolding angle: To facilitate demoulding, wall of plastic product should have an draft angle α in...

News2024-10-22



Reverse modeling and die-casting mold design of aluminum alloy die-casting part

In order to quickly respond to market and improve R&D efficiency, shell of an aluminum alloy signal ...

News2024-10-21



Design of injection mold for oil pipe elbow of injection molding machine

For plastic parts in Figure 1, setting of parting surface is mainly subject to following factors whe...

News2024-10-21



Research on local pressurization process of aluminum alloy bracket die-casting parts

Die-casting process is widely used in automobiles, mechanical equipment, home appliances and 3C prod...

News2024-10-19



Introduction to multi-stage injection molding process

Multi-stage injection molding is a molding method in which screw has different injection speeds and ...

News2024-10-19