Pollution is primary culprit for failure of hydraulic system of injection molding machine!

Quality of hydraulic system of injection molding machine depends not only on rationality of system d...

News2024-10-05



Verification and process optimization of large automobile die-casting mold design by PQ2 diagram

Since advent of pressure casting in the late 1860s, for a long time, design of gate system and its a...

News2024-09-30



Design of injection mold for refrigerator drawer

Structure of refrigerator drawer is complex. As shown in Figure 1, upper part of front side is an ar...

News2024-09-30



Talking about mold optimization from perspective of injection molding process 1

In addition to mastering basic drawing knowledge (such as mechanical drawing, tolerance standards, d...

News2024-09-29



Research on properties of new high-strength die-cast aluminum alloys

Evolution of microstructure and properties of a new high-strength Al-Si-Mg-Mn alloy was studied. Bas...

News2024-09-25

Key points of injection molding technology for TPU mobile phone protective cases.

There are many methods of TPU molding process: including injection molding, blow molding, compressio...

News2024-09-25



Entering world of "magnesium" | Magnesium alloy die-casting technology and process

As a rapidly developing green and environmentally friendly alloy, magnesium alloy has low density (1...

News2024-09-24



Technical key points of injection molding to produce transparent products.

Due to high light transmittance of transparent plastics, surface quality of plastic products must be...

News2024-09-24



Mold design affects quality of aluminum die castings

With development of science and technology, requirements for safety and aesthetic appearance of die-...

News2024-09-23



Automobile sensor bracket mold

This case is a bracket on a sensor of a car. Precision requirement is very high, material is POM, pr...

News2024-09-23