Design of injection mold for refrigerator drawer

Structure of refrigerator drawer is complex. As shown in Figure 1, upper part of front side is an ar...

News2024-09-30



Talking about mold optimization from perspective of injection molding process 1

In addition to mastering basic drawing knowledge (such as mechanical drawing, tolerance standards, d...

News2024-09-29



Research on properties of new high-strength die-cast aluminum alloys

Evolution of microstructure and properties of a new high-strength Al-Si-Mg-Mn alloy was studied. Bas...

News2024-09-25



Key points of injection molding technology for TPU mobile phone protective cases.

There are many methods of TPU molding process: including injection molding, blow molding, compressio...

News2024-09-25



Entering world of "magnesium" | Magnesium alloy die-casting technology and process

As a rapidly developing green and environmentally friendly alloy, magnesium alloy has low density (1...

News2024-09-24

Technical key points of injection molding to produce transparent products.

Due to high light transmittance of transparent plastics, surface quality of plastic products must be...

News2024-09-24



Mold design affects quality of aluminum die castings

With development of science and technology, requirements for safety and aesthetic appearance of die-...

News2024-09-23



Automobile sensor bracket mold

This case is a bracket on a sensor of a car. Precision requirement is very high, material is POM, pr...

News2024-09-23



Aluminum alloy automobile steering knuckle precision casting process sharing

Precision casting process of an aluminum alloy automobile steering knuckle is designed and optimized...

News2024-09-20



Analysis and solutions for causes of bubbles in plastic products

In injection molding, bubbles are not a very common defect for general small processing workshops. B...

News2024-09-20