Process sharing-TPU injection molding process

Hardness of TPU is usually expressed by internationally recognized Shore hardness. In general, A is ...

News2020-05-14



Dimensional control analysis from molding design to product end

With rapid development of mold industry in recent years, application range of new technologies and ...

News2020-05-13



How to design a mold for plastic injection molding?

First, pre-processing of product
Many mold designers take a product and start to rush into mold. In...

News2020-05-12



Injection mold design thinking process

A mold is a tool that imparts a fixed geometry to finished product to repeat mass production of fini...

News2020-05-11



A set of classic molds, difficult in the details!

This is a medical dropper, which was commissioned by a friend in United States. It has some difficul...

News2020-05-09

Mould Design Sharing——Determination of product demoulding mode

Product demoulding mode refer to which method is used to eject product after injection molding is ...

News2020-05-08



Key points in the design of precision injection molding parts for cars

Most of plastic moulding parts of car are injection-molded. Due to high design precision of these p...

News2020-05-07



Application of 3D printing technology in the design of injection molding

In recent years, with rapid development of 3D printing technology, great progress has been made in m...

News2020-05-06



How much does temperature of injection molds affect injection molding process?

injection molding process, injection molds, injection molded parts, mold temperature machine, temper...

News2020-05-05



Demoulding slope is not good, demould cannot be finished even if it is good!

Draft angle is slope designed on both sides of cavity for convenience of ejection. Orientation of d...

News2020-05-04