Mold Structure: Push Plate, Double Ejection, Complex Slides

Time：2025-10-07 08:21:31 / Popularity： / Source：

1. Product

II. Mold Structure
1. Sliders 1 and 2 are half-length slides, used with hydraulic cylinder core pullers. Sliders 3 and 4 are assembled using a sectional assembly.

2. Inserts secure slide plate with core pullers

III. Mold Base Model

IV.Fully 3D Mold

Last article：Design of an Injection Mold for a Power Plug-in Housing Next article：Aluminum Alloy Die-Casting Defect Research Based on "AI + X-ray Inspection"

Introduction to die casting and post-processing technology10-19
Design of a Two-Step Ejection Injection Mold for Inner Panel of a New Energy Vehicle Door10-19
Molding Cycle Reduced from 28 Seconds to 19 Seconds: Key Considerations for Conformal Cooling Design10-17
Three Lectures on Core Technologies of Plastic Injection Molds: Gating System, Cooling System, and D10-16
Plastic Materials (Part 4): In-depth Analysis of PP-GF10-16

Go To Top

Gud Mould Industry Co., Ltd

Mold Structure: Push Plate, Double Ejection, Complex Slides

Recommended

Related