News
Design of flip-chip injection mold for new energy vehicle door handle based on CAE technology
Figure 1 shows a door handle of a new energy vehicle. Material is polycarbonate / acrylonitrile-bu...
News2024-04-28
Optimization of automotive oil pump body die-casting process
In order to meet requirements of high air tightness and high strength of automotive aluminum alloy o...
News2024-04-26
Plastic structure design 6 —part gaps, buckles and stops
This article mainly introduces requirements for parts clearance, buckle positions and stops in desig...
News2024-04-25
Improve performance of die-casting molds and extend service life of die-casting molds
Pressure casting (die casting for short) has characteristics of high production efficiency, short pr...
News2024-04-19
Electric vehicle front cover hot runner mold design
Electric vehicle front hood is shown in Figure 1. Average wall thickness is 2.2mm. Outer wall of pla...
News2024-04-19
Automotive light bracket die-casting process analysis and mold design
Structural characteristics of automobile light bracket were analyzed, die-casting process was design...
News2024-04-18
Common causes and solutions for misjudgment of plastic product quality
As saying goes: "No one is perfect, no gold is pure, no one is a sage, no one can make mistakes!" ...
News2024-04-18
Die casting production case! Research on vacuum die-casting LED lamp radiator castings
Magnesium alloy has characteristics of high specific strength and specific stiffness, good impact re...
News2024-04-17
Contactor base injection mold design
Base is similar to a semi-enclosed box-shaped piece. Coil is installed inside box surrounded by vert...
News2024-04-17
Analysis and solutions for thermal cracking of die-cast ADC12 aluminum alloy mobile phone middle fra
Abstract: Causes of thermal cracking of middle frame of die-cast ADC12 aluminum alloy mobile phones ...
News2024-04-16